Thursday, 11 November 2010

More embossing

I attempted to make a 3d stamp to emboss in the print room using the wheel with raised letters on card, however I don't think the letters were raised enough in order to produce a deep enough emboss.

I've been trying out more variations of my logo as using the whole two words "1st class" is proving to be too long and difficult to get accurate when cutting out. I am contemplating screen printing the 'class' underneath the 'st' or leaving it as just "1st" because I do quite like the look of it and it fits a lot easier onto each net

No comments:

Post a Comment